View selectionvector

Introduction

A selectionvector is the basis for creating the initial automated requirements tailoring. For each tailoring two possible different selectionvectors will be stored.

• calculated based on screeningsheet parameters
• applied selectionvector which can differ from the calcuated one

The selectionvector parameter/values depends on the tenants implementation. The screens shown on this page are the example perimeter of the demo tenant.

It might by that the case that not all data could be displayed without scrolling.

Step 1: Open project tailorings

Tailorings

Action

• Click to open the selectionvector dialog.

Step 2: Click

A dialog with the applied sectorvector is openend.

Applied selectionvector

Actions

• Click Close to close the dialog