Edit requirement
Introduction
During the creation of a new tailoring, requirements of the selected base catalog will be selected according to the project perimeters and the used selectionvector. This tailoring is the baseline to fine tune.
It is possible to manual change
- applicability
- text
of a requirment
Step 1: Open project tailorings
Actions
- Click to get to the project tailorings
Step 2: Open requirements of tailoring
All tailorings of selected project are shown.
Actions
- Click in Actions section to open requirements catalog.
Step 3: Select a requirement to edit tailoring
All tailoring requirements are displayed in a tree organised into chapters.
Actions
- Select a catalog chapter. All direct requirements will be shown on the right.
Step 4: Select a requirement to edit
The requirement will be open in an editor overlay.
Actions
- Modify text
- If you want to update the requirement, click SAVE
- If you don’t want to update the requirement, click CANCEL
Step 5: Change state of requirement
All tailoring requirements are displayed again.
Actions
- Click the chip element to toggle applicability state of a requirement.
Step 5: Return to project cockpit
All tailoring requirements are displayed again.
Actions
- Click the project name in breadcrumb to go back to the cockpit